OSD Task Sequence Failed – 0x80070BC2
I’m looking for some guidance/support regarding an SCCM issue I have been having for the past week.
Imaging is completing via the TS but no apps are installed. Only error in the smsts log is 0x80070BC2 followed by a reboot and activating the finish page. I have swapped out the DP and tested in a different UK location but the same issue, once the user logs on after imaging those apps, install fine. I have created a new TS and tested in UK but it still fails to installs the apps. The point where it stops is a few steps after installing the config client.
If the same TS is ran in another country it works fine. As the UK TS works fine in another location I thought it wouldnt be the actual TS itself and something local instead.
We have ran packet capture whilst imaging and cannot see any packet drops during imaging that could be causing the issue.
Sccm is 2010, also tried to run another TS in UK which does the same but that TS works fine in another country.
Any help/suggestions are welcome.