Task Sequence to Deploy OS for Dell Precision 5820 can not PXE boot
Question
Hi All,
I created MDT Task Sequence to deploy OS for Dell Precision 5820 Tower but I cannot PXE boot.. no response to F12 or F10.
PXE boot is enable on workstation and I already added the drivers in the MDT Out-of-Box-Drivers.
In addition, I updated Deployment Share and completely regenerated the boot image after adding the drivers. Please advise.
Posted by Dev Rawal in HTMD FB Group
Answers ( 2 )
Replied by Doug Lanham
Robbert Verbeek ^Yep. What he said. Make sure the bios is configured properly. We generally set it to AHCI and turn on the UEFI boot stack and it’ll PXE.
Replied by Pierre-Paul Duval
Make sure the network stack is enabled in the BIOS
Replied by Sourav Mondal
R u getting the pxe boot screen if not. Can u press f8 if you have command prompt support and check if it is picking up correct ip or not.
If you can see the correct ip then can you check if you can see the hard drives or not of that device
Moreover beside adding the drivers in the ts and as you said you have updated the deployment share and boot image I feel you have added the storage and network drivers in the boot image and then updated the deployment share if I m not wrong.
Replied by Robbert Verbeek
Also, in newer Dell UEFI only bios, AHCI is set to RAID, so you need to add the Intel RST Storage drivers too in bootimage, otherwise WinPE will not see the disk