Dell laptop 5310 starting to imaging using Offline TS ISO image
Question
Help me to sorted out this..Am stuggiling to complete this..Thank you
Dell laptop 5310 starting to imaging using Offline TS ISO image ..TS having Reboot in Win Pe, Partitioning, Apply OS, Drivers and setup and config manager setup.After completing the setup and config manager setup laptop rebooted and starting again from USB ..
Answers ( 5 )
No response hence closing the thread
This is very generic error. It’s not much helpful …
Check one or lines above and below this error and under the real issue
I checked and found the smsts.log
1.failed to validate the Boot image in staging
2.stage Boot image failed 0x80070490
3.failed to stage a Boot image
4.failed to reboot the system error 0x80070490
5.failed to initialize a system reboot.
Please check and confirm…
First try to check the boot order in the BIOS. If the USB is a higher priority than the hard drive, it would cause it. Mostly try to check when device is getting restart for first time.
Secondly, You could try to update BIOS and check your observation!
This type of behavior has been observed with DELL Models.
Refer this thread – https://www.reddit.com/r/SCCM/comments/840whr/winpe_keeps_restarting_to_usb/
I think you need to look SMSTS.log –> SCCM OSD Task Sequence Troubleshooting Steps by Step Ultimate Guide with SMSTS.log
https://www.anoopcnair.com/sccm-osd-troubleshooting-using-smsts-log-with-vishal-configmgr/
this analysis will help you understand the issue.